Connect Kdc To Pc; Charge Kdc Battery - KoamTac KDC100 User Manual

Connect KDC to PC

The KDC is equipped with one ultra mini USB port. If you have the KDC100, it has two ports, Ultra Mini
and standard Type A which swings out. See Figure 2 for more details. The USB port is used to upload
barcode data and to charge the KDC battery. Prior to using the KDC, your PC must recognize the KDC.
With the USB cable that came with the KDC, connect the KDC to your PC. Follow these directions for
connecting the KDC to your PC.
1. Connect the cable's ultra mini USB connector to the KDC.
2. Connect the cable's Type A USB connector to your PC.
3. Wait until your computer beeps and displays the message New Hardware Found.
4. Follow the prompts to search for the KDC device driver. The device driver is located in the KDSync
directory created when you copied the CD contents to your PC.
5. Select KDSync directory and KTReader.inf file.
6. Continue with the hardware installation procedure.

Charge KDC Battery

After installing the KDC, you must charge its battery. To charge the battery, follow these directions.
1. Connect the cable's ultra mini USB connector to the KDC.
Connect the cable's Type A USB connector to your computer.
2.
3. Your KDC battery will begin charging. Two small LEDs on the front panel will illuminate orange.
When the battery is fully charged, the LEDs will illuminate green.
KDC100
2 Hours
Table 2 – Approximate Time to Charge KDC Battery
KDC200 KDC200P
2 Hours 2 Hours
11
KDC300 User Manual
KDC300
4 Hours