Connect To Kdc - KoamTac KDC100 User Manual

4.1 Connect to KDC

The KDC connects to a COM port automatically when connected to your PC's USB port. After the port is
assigned, you must manually assign the KDC to its assigned COM port in KTSync
assign the KDC COM port using KTSync
The COM port assignment is found in the Windows Device Manager.
®
KTSync will not connect to the KDC if it is in KDC Mode Menus.
You must EXIT the KDC from the Menus before KTSync
®
If KTSync
1. Exit KTSync
2. Check that you have connected the KDC to a USB port on your PC.
3. Make sure to use the cable provided with the KDC.
4. Check that the KDC is not in KDC Mode Menu.
5. Restart KTSync
®
Figure 10 - COM Port Selection for KDC
fails to connect automatically to the KDC, please follow these directions.
®
.
®
.
Connection submenu under File menu if needed.
®
28
KDC300 User Manual
®
. You can manually
will connect to the KDC.