Lcd - Arctic Cat 550 H1 EFI Manual

3. Tighten the jam nut securely.
„
NOTE: The ATV is equipped with
an RPM limiter that retards ignition
timing when maximum RPM is
approached. When the RPM limiter
is activated, it could be misinter-
preted as a high-speed misfire.

LCD

„ NOTE: All segments of the LCD
will activate for approximately two
seconds when the ignition switch is
rotated to the ON position.
1. Clock/Engine Hour Meter - The clock
function indicates time in the 12-hour
mode; the hour meter indicates the
total time the ATV has run and cannot
be reset to zero. To set the clock, use
the following procedure.
A. With the ignition switch ON,
press and release the Mode But-
ton (3) until the Clock/Engine
Hour Meter (1) is displayed;
then (if necessary) press and
release the Set/Reset Button (4)
to select the clock display.
B. Press and hold the Set/Reset
Button (4) until the minutes stop
scrolling and the hour display
starts to scroll. Momentarily
release when the correct hour is
displayed; then repeatedly press
and release the Set/Reset Button
(4) until the correct minutes are
displayed.
„
NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
"power-up" and reset. In the event
of clock memory power failure
(blown fuse, etc.), the gauge will
"power-up," reset, and shut down
repeatedly
power is restored. Always check the
15-amp accessory fuse if
gauge condition is noted.
„
NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the
engine coolant temperature exceeds
the normal operating range, the
temperature icon will begin flash-
ing and the LCD will go blank for
30 seconds; then the LCD will
return to normal. However, the tem-
perature icon will continue to flash.
CAUTION
ACE-015B
Continued
engine temperature may result in
engine damage or premature wear.
„ NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine temperature.
engine RPM, reducing load, and
selecting an appropriate transmission
gear can lower the temperature.
„ NOTE: Debris in front of the
engine (or packed between the
cooling fins of the radiator) can
reduce cooling capacity. Using a
hose, pressure-wash the radiator
and the engine to remove any
debris restricting air flow.
3. Mode Button - Shifts the gauge
through three set-up modes: speedom-
eter/tachometer, distance, and time.
„ NOTE: The Mode Button must be
pressed and
modes. Approximately two seconds
after the Mode Button is released,
the digital gauge will return to full
display.
until clock memory
this
operation with high
Decreasing
released to shift
41