Carf-Models Ultra Flash Instruction Manual page 44

The next pictures show a finished plumbing installation. In this installation the inlet duct joiner in not
used as it is not needed. If you still want to use the inlet duct joiner you will have to arrange your
tubing and wiring different so it doesn't affect the installation. Also, you will have to slightly cut
certain areas of the duct joiner to make it still fit, because with the saddle tanks installed it is very
tight.
We anyways recommend leaving the inlet duct joiner out once the saddle tanks are installed, but
we then highly recommend installing a FOD Guard to prevent any dirt to get into the Engine.
Important note: Make sure your tubing to both tanks is exactly the same length, otherwise
they will not fill and empty identical due to different flow restriction.
Your CARF Models Team