Connections Of Pre-2Dsp - YBA DESIGN Pre-2DSP Owner's Information

Preamp-processor

Hide thumbs

Table Of Contents

Table of Contents

1. 5.1 Audio Output

a. Center Channel Output

Connect the Center channel output of your Pre-2DSP to the input of a mono amplifier or to

the channel of the multi-channel amplifier that is connected to your center (C) speaker.

b. Subwoofer Output

Connect the subwoofer output of your Pre-2DSP to the input of active subwoofer.

c. Left and Right Rear Channel Outputs

Connect the Left and Right rear outputs of your Pre-2DSP to the input of the two channel amplifier

or to two channels of a multi-channel amplifier that are connected to your left and right surround

(LS, RS) speakers.

d. Front Left and Right Channel Outputs

Connect the Left and Right Front channel outputs of your Pre-2DSP to either the inputs of a two

channel amplifier or to two channels of a multi-channel amplifier that are then connected to your

main front left and right (L, R) speakers.

2. 5.1 Analog Inputs

The 5.1 Analog Input are designed to accept up to six channels of processed analog output from

a DVD player or DVD Audio player other component with discrete outputs. Connect the six discrete

outputs of your source component to the corresponding 5.1 Analog Input of the Pre-2DSP .

3. A2 A3 Analog Audio Input Connections

The A2 A3 analog inputs are compatible with typical analog line level sources such as CD players,

MiniDisc players, cassette decks, etc. connect the left and right analog audio outputs of your

audio/video source components to these inputs.

4. A4 Input and Rec (Record and Playback) Connections

Use the A4 inputs and outputs for the VCR you intend to use to record the picture and sound. The

signal present at the V4 Record output sends analog audio from whichever of the other A2 A3

V2 V3 Audio/Video or Audio-only inputs you select.

1. Connect the left and right audio output connectors from the VCR you'll use for recording

to the A4/V4 Input connectors of the Pre-2DSP .

2. Connect the left and right A4 REC (Record) Output connectors of the Pre-2DSP to the left

and right audio input connectors of the VCR.

3. Connect the composite video output connector of your VCR to the V4 or S4 input of the

Pre-2DSP and connect the V4 REC or S4 REC Composite Record Output connectors of the

Pre-2DSP composite video input connectors of the VCR.

5. Tape monitor play and REC Connections

The audio signal from the source you selected for the main zone is routed to both pairs of Record

Output connectors. Connect the lift and right play/output of your tape deck to the left and right of

any of the Pre-2DSP's A2

record/input connectors of your tape deck to either pair of Left and Right channel Record Output

connectors of your Pre-2DSP .

6. Digital Audio Input Connections

Your Pre-2DSP has four digital input connections: three Coax RCA jack, one Optical Toslinks.

a. Coaxial Digital Inputs

The four Coax Inputs on the Pre-2DSP accept a standard S/PDIF digital bitstream form any CD

player, DVD player, DSS receiver, or other digital component equipped with a 75