Table of Contents
Advertisement
Repeatedly pressing DRC Button will circle among 3 modes, and the 3 modes are explained as
below:"NO" means no compression is performed to the original audio signal, this gives listener the
greatest dynamic range.
"HALF" means the audio signal is partially compressed, this function is useful if Pre-2dsp is
connected to an external amplifier.
"FULL" means the audio signal is completely compressed, this function is useful if Pre-2dsp is
connected to an external amplifier.
Press the DRC Button will display the current setting of Dynamic Range Compression mode.
DRC Button
Press the DRC Button again will circle the DRC mode.
DRC Button
Note: This function only using the RC-5 code remote control can works.
Note: This function only using the RC-5 code remote control can works.
This section is to help you solve the problems you might encounter common question and answer
regarding installation and connection are listed below for your reference, in case these menthods
do not solve the problem, contact technical support for further assistance.
PROBL EM
No power
No sound
No sound from the rear
speakers
No sound from the (front)
center speaker
Remote control unit does not
operate.
OSD functio n is no t availa ble.
Freguency Response:
Harmonic Distortion:
Impedance:
A1 Analog lnpu :
A2.A3.A4.TAPE analog lnput:
DRC Button
TROUBLESHOOTING
TROUBLESHOOTING
POSSIBLE C AUSE
The AC input cord is disconnected.
Poor connection at AC wall outlet or the
outlet is dead or off.
The speaker wires are disconnected.
The master volume is adj u sted too low.
The MUTE button is pressed to ON.
Input volume of power amp is too low.
The dig ital inpu t is not s electe d.
Incorrect selection of input source.
Incorrect connections between the components.
The field mode is not correct selected.
( stereo mode)
Master volume and rear level are too low.
Monaural source is used.
Rear speaker setting is "N".
Tru surround, normal stereo mode, etc is
selected.
(Front) center speaker setting is "N".
Master volume and center level are too low.
Batteries are not loaded or exhausted.
The remote sensor is obstructed.
Video connections between this unit and the
monitor TV are not made correctly.
SPECIFICATIONS
SPECIFICATIONS
10Hz-20KHz
<0.015%
47K
10K
Connect cord securely.
Check the outlet usi n g a lamp or another
appliance.
Check the speaker connections.
Adjust the master volume.
Press the MUTE button to cancel it
Adjust the input volume of power amp.
Selec t the d igital inp ut.
Select the desi r ed input source correctly.
Make connections correctly.
Select the correct field mode.
Adjust master vol u me and rear level.
Select a stereo or surround source.
Select the desi r ed rear speaker setting.
Select the desi r ed surround mode.
Select the desi r ed (front) center speaker
setting.
Adjust master vol u me and center level.
Replace the batteries.
Remove the obstacle.
Make proper video connections.
Field:
Disable, Hall , Theater, Stadium,
Club, Church
Prologic:
Prologic auto, Prologic all pcm.
Prologic enable, Prologic disable.
23
REMED Y
Reverb 0~9
Advertisement
Table of Contents
