Table of Contents
Advertisement
FRONT PANEL FUNCTIONS
FRONT PANEL FUNCTIONS
9
1
1. POWER Button
1. POWER Button
This button to turns ON or STANDBY Pre-2DSP .
ON
STANDBY
2. EQ ON/OFF Button
2. EQ ON/OFF Button
Activate the selected EQ band setting
3. REC ON/OFF Button
3. REC ON/OFF Button
Press this button will be on and press again will be off.
4. EQ SETUP Button
4. EQ SETUP Button
Select up to 5 EQ band settings.
5. FIELD Button
5. FIELD Button
Select among 6 different sound fields
6. INPUT/SELECT Button
6. INPUT/SELECT Button
Select different source inputs.
Select the length of Delay time for SL/SR/C channels.
Delay
Select the length of Balance for L/C/R/SL/SR/LFE channels.
Balance
Select the length of Test/M for L/C/R/SL/SR/LFE channels.
Test/M
Select up to 5 EQ Band +/- adjusts.
EQ Band
Select bass crossover (80Hz, 90Hz, 100Hz, 110Hz, 120Hz)
bass
11
12
13
10
2
3
4
5
6
7. VOL/ADJUST Button
7. VOL/ADJUST Button
Increase/decrease the Volume level .
Increase/decrease the Delay times.
Increase/decrease the Balance level.
Increase/decrease the EQ level.
8. BALANCE Button
8. BALANCE Button
First press this button then press vol button to set
5CH output volume.
Custom set the volume setting for 6 channels.
9. POWER Indicator
9. POWER Indicator
This red color LED lights up when STANDBY.
This green color LED lights up when POWER ON.
10. BYPASS Indicator
10. BYPASS Indicator
This red color LED lights up when Bypass ON.
11. TAPE Monitor Indicator
11. TAPE Monitor Indicator
This green color LED lights up
Monitor ON.
Monitor ON.
5
14
15
7
8
12. REMOTE Sensor
12. REMOTE Sensor
This sensor receives a signal from the remote
Volume
handset.
Delay
Balance
13. LCD Display
13. LCD Display
EQ
This display provides you with important
information regarding system status and
settings.
It is important to be familiar with all the
indications on the display in order to have the
system function properly.
14. EX-SC Indicator
14. EX-SC Indicator
U P - G R A G E f o r E X 6 . 1 .
STANDBY.
15. Speaker Configuration LEDs
15. Speaker Configuration LEDs
POWER ON
Each LED represents the status of an individual
channel. When a particular channel is active,
the LED LIGHTS UP . Red color LED light means
Bypass ON.
this particular channel has been set to output
a wider frequency range that contains bass
signal between 20Hz to 120Hz.
Green color LED light means this particular
when Tape
Tape
channel doesn"T contain the bass signal
between 20Hz to 120Hz.
Advertisement
Table of Contents
