Recommendations - YBA DESIGN Pre-2DSP Owner's Information

Preamp-processor

Hide thumbs

Table Of Contents

Table of Contents

Digital lnput:

Signal/Noise Ratio:

Video Input Impedance:

Component Video:

R-Y signal, B-Y signal:

Y-Signal:

Power Consumption:

Function Crontrols:

Volume:

Balance: L,C,R,SL,SR,LFE,

Delay Time : Center

Delay Time : Rear (SR,SL)

Test:

Note: Design and specifications are subject to change without notice for improvements.

Do not place Pre-2DSP on a glass shelf. If you really must, use "Altuglass" on the shelf. We do highly

recommend placement on wood or granite.

For best sonic results, correct orientation of the AC plug is important. The prong with the red dot

should be connected to the "hot" connection of your wall socket.

Check the quality of your AC cords and power strips (unlighted power strips are preferred).

For best results, the Pre-2DSP should initially be broken in with 30 hours of play. A warm up of 1

hours is best whenever the unit has been switched off.

It is preferable to leave your Pre-2DSP permanently Standby (Power indicator is red). The power

consumption is low and the sonic benefits are high.

In order to maintain good sonic quality, it is recommended that you do not stack the Pre-2DSP

and the Power amplifier on top of each other. The best is to place them separated, one on the

left and the other on the right. This is to ensure that the electromagnetic interference emitting

from the transformers of the high-current power amplifier will not affect the Pre-2DSP, and thus

causes deterioration in the overall sonic quality.

YBA GLASS, CRISTAL or DIAMOND interconnect & speaker cables will give the best sonic result.

0.5V P-P /75

90dB

1.0V P-P /75

0.5V P-P /75

1.0V P-P /75

45W

-80 ~ +10dB

-12dB~0dB

0ms ~ 5ms

0ms~15ms

L/C/R/SL/SR/LFE