Saving Presets; Loading Presets; Bypass Setting - YBA DESIGN Pre-2DSP Owner's Information

In case of converting Prologic or 2 - channel Dolby Digital signal into Stereo mode, you can
press the Prologic Button until you see the display with following information Prologic Button
The Pre-2dsp allows you to customize up to 5 settings. This function allows you to program, save
and load Your favorite configurations at any time you want.
Preset settings Preset settings
Press the PRESET 1 Button will display PRESET 1 Button
Press SAVE Button to save all current decoder settings into Preset 1. SAVE Button
When complete, Pre-2dsp will shift back to Auto Decode mode.
You can load previously saved preset by Pressing LOAD Button on the remote.
Preset 1 Preset 1
Press any of the 5 preset buttons, ( PRESET 1 , PRESET 2 , PRESET 3 or PRESET 4 , PRESET 5 ) , the display
will Show the following information
Press LOAD Button to execute. LOAD Button
When preset loading is completed, Pre-2dsp comes back to Auto Decode mode.
Pressing this button the LED on front panel will lights up in red color.
Press this button the input signal does not go through dsp processing it will directly go through by
volume control but input selection should be in A2 A3 A4 analog position.
When the input selection in A2 A3 A4 position but you press the tape monitor button (under the
chassis) the bypass function does not works.

SAVING PRESETS

SAVING PRESETS
LOADING PRESET LOADING PRESET
LOAD Button
( PRESET 1 , PRESET 2 , PRESET 3 or PRESET 4 , PRESET 5 )

BYPASS SETTING

BYPASS SETTING
21