Master Volume Control; Balance Setting; Mute Mode - YBA DESIGN Pre-2DSP Owner's Information

Preamp-processor

Hide thumbs

Table Of Contents

Table of Contents

Volume Setting

To increase or decrease the master volume of Pre-2dsp, simply press VOL + or VOL - on the remote

control.

Example : Volume being decreased by 35 decibels.

VOL

+ +

_ _

Adjust

Balance button

Users can customize the volume setting of each individual channel.

To select a channel , press Balance Button on the remote control. Press Input/Select Button epeatedly

until desired channel is reached.

Example:

Adjust volume on selected channel by pressing VOL + or VOL - on the remote control.

Press Balance Button will display the current balance volume for channel L.

Balance Button

Press

Input/Select Button

Input

+ +

Balance

_ _

Select

Press VOL + or VOL - will increase or decrease the balance volume for selected channel.

VOL +

VOL -

Press

Balance Button

Adjust speaker volume levels so that when listening to sound position, the testing sound volumes from

every speakers are the same level.

Notice:

Notice: The volume from sub woofer speaks sounds level lower than actual sound. After actual testing

of sounds, it might be necessary to adjust the volume level a bit higher.

If you are using sound pressure level (SPL) meter to test and adjust:

Obtain the reading from your main listening position, and adjust the levels of speakers to 75dB SPL (C

weighted/slow mode).

Pressing Mute Button on the remote control can interrupt all signal outputs (6 RCA connectors.)

Mute Button

To disable the mute function, press Mute Button again.

When Mute Button is pressed, display shows the following information:

Mute Button

Mute