Vcd7000 Vehicle Cradle; Charging The Eda Battery; Removing The Eda - Motorola MC70 User Manual

VCD7000 Vehicle Cradle

This section describes how to use a VCD7000 vehicle cradle with the EDA. For cradle installation and
communication setup procedures refer to the MC70 Integrator Guide.
Once installed in a vehicle, the cradle:
• holds the EDA securely in place
• provides power for operating the EDA
• provides a serial port for data communication between an EDA and an external device (e.g., a printer)
• re-charges the battery in the EDA
• re-charges a standard capacity or extended capacity spare battery.

Charging the EDA Battery

Insert the EDA into the vehicle cradle to begin charging. A click indicates that the EDA button release locking
mechanism is enabled and the EDA is locked in place.
Figure 6-7 EDA Battery Charging
Ensure the EDA is fully inserted in the cradle. Lack of proper insertion may result in property damage or
CAUTION
personal injury. Zebra is not responsible for any loss resulting from the use of the products while driving.

Removing the EDA

To remove the EDA, hold back the release lever on the cradle and pull the EDA up and out of the cradle.
Release Lever
Accessories 6 - 7