1 - 4
MC70 User Guide
Getting Started
To start using the EDA for the first time:
•
Install the main battery and cover assembly.
•
Charge the EDA.
•
Power on the EDA.
•
Configure the EDA.
Installing and Removing the Main Battery
Installing the Main Battery
Before using the EDA, install a lithium-ion battery. Depending upon the configuration, the MC70 may ship with a
1900 mAh, 3600 mAh or 3800 mAh battery. The 1900 mAh battery is shown. The extended capacity batteries
requires a larger capacity battery cover. When using the 4800 mAh battery (light gray color), ensure that the 4800
mAh battery door is used.
Insert the battery, top first, into the battery compartment in the back of the EDA.
1.
Press the battery down into the battery compartment until the battery release latch snaps into place.
2.
Battery
Release Latch
Inserting the Battery
Figure 1-3
NOTE Position the battery correctly, with the battery charging contacts on top of the charging contacts in the
battery compartment.
With the battery cover latches open, insert the cover, bottom first, then press down on the top of the cover.
3.