Install The Windows Network Driver - NETGEAR Sb 104 Installation Manual

Install the Windows Network Driver

This guide provides you with instructions for installing a Windows 95 or
Windows 98 network driver. All versions of Windows might not respond with
the same screens. Therefore, windows that are different from those shown in
these instructions might open but prompt you for the same information, and
windows might open in a different order than the order of the steps in these
instructions.
Note: You must install the network card (instructions on other side of
this guide) before installing the network driver.
You need to have the Windows CD and the FA310TX Drivers and Diagnostics
Disk ready to use in the installation process.
If you have not yet named your PC and your network, before you proceed with
the installation steps, decide on a name for your network and for each PC. When
the "Network" window opens, it prompts you with the message that "you must
provide computer and workgroup names...." Click on "OK." The second
"Network" window opens and prompts you for the names. Enter a name (a
different one-word name for each computer) in the "Computer name" entry
field; enter a workgroup name (the name of your entire network) in the
"Workgroup" entry field. Click on "OK" or "Close."
Note: If the "Insert Disk" window opens and a message prompts you to
insert your disk at any time during the installation process, insert the
Windows CD in Drive D (the CD drive) and click on "OK." Then
follow the next step in the instructions.
1. Turn on the power to the computer and start Windows.
The new hardware is found.
2.
Insert the FA310TX Drivers and Diagnostics Disk in Drive A, and then
click on "Next."
Model SB104 10 Mbps Network Starter Kit Installation Guide