Install The Hub - NETGEAR Sb 104 Installation Manual

Install the Hub

1. Set the hub on a flat surface or mount it on a wall and choose a location
that:
• Is close to an electrical outlet.
• Exposes the front and rear panels to allow connection of the network cables
and easy monitoring of the LEDs.
• Places the hub and PCs close enough to connect the network cables.
To install the hub on a wall, measure the distance between the mounting
holes at the back of the hub and mark the wall to match the location of the
mounting holes. Drill pilot holes at the two marked locations on the wall and
screw two 5/16-inch diameter flathead screws (provided) into the wall so
that the screws protrude 1/18 inch to 3/16 inch. Slide the hub down onto the
screws.
2. Turn on power to the hub by connecting the power adapter.
3. Verify that the Pwr (power) LED is on.
If the Pwr LED is not on, the hub is defective and should be returned to your
point-of-sale representative.
4. Make sure that the Normal/Uplink push button is set to Normal.
The push button is set to Uplink only if port 4 is connected to another hub
for expansion purposes.
Link LED Rx LED
Pwr LED
Col LED
RJ-45 ports
Ground clip
(not used)
Model SB104 10 Mbps Network Starter Kit Installation Guide
Normal/Uplink push button
(Normal position when
connected to a PC)
Power adapter
receptacle
7979FB