Replacing Printed Circuit Board F1, F2/Slide Volume - ELNA 9500 Service Manual

Replacing Printed Circuit Board F1, F2/Slide Volume

w
e
r
(B)
q
(A)
Printed circuit board F1
To remove:
1 Remove the front cover.
2 Pull out the connector from the printed circuit
board A.
3 Remove Screws (A) (2 pieces) and remove
the Printed circuit board F 1
To attach:
4 Follow the above procedure in reverse.
Printed circuit board F2
To remove:
1 Remove the front cover.
2 Pull out the connector from the printed circuit
board A.
3 Remove Screws (B) (3 pieces) and remove
the Printed circuit board F 2
To attach:
4 Follow the above procedure in reverse.
Slide volume
To remove:
1 Remove the front cover.
2 Pull out the Slide volume connector from the
printed circuit board A.
3 Remove the CS ring
r
the slide volume
To attach:
4 Follow the above procedure in reverse.
13
9500
q
.
w
.
e
(2 pieces) and remove
.