Rinnai ENERGYSAVER EX08C Installation Fundamentals page 47

Vent Termination
ATTACHING THE SLEEVE
1. Slide the sleeve through
the interior side of hole.
Ensure label "Top" is
installed at the top of hole.
2. Ensure the
sleeve extends
3/16" to 3/8" (5-
10 mm)
NOTE: The flange
is offset 2°to
allow condensate
to drain outside
Practice good safety habits when using
CAUTION
power equipment tools!
3. Attach the sleeve to the
inside wall using 3
screws. If needed, use
sheet rock anchors to
secure to wall.
47