Table of Contents
Advertisement
at
The
manufacturer
responsibility in the event of failure
to observe the instructions given
here for installation, maintenance
and
suitable
product.
The manufacturer further
declines all responsibility for injury
due to negligence and the warranty
of the unit automatically expires due
to improper maintenance and/or
installation.
(Not applicable if the range hood is
used in re-circulating mode)
WARNING: Do not vent this
appliance into any other ductwork,
spaces between walls, ceilings,
attics, garages or any other confined
External Venting Requirements
When planning new ductwork, always
look for the most direct route to the
outside. Venting can be done through
the roof or directly through the back
outside wall. (See Figure 1 )
Only use rigid type metal ducting
(plastic ducting is generally not permit-
ted by code). Flexible ducting could
restrict airflow by up to 50%. Always
fasten connections with sheet metal
screws and tape all joints with certified
Silver Tape or Duct Tape. Do not use
screws to fasten
the hood, only use tape as the screws
will stop the dampers from opening
and your hood will not work.
hood requires a 6" round duct outlet.
You can increase the duct size of the
duct run but never decrease it. Use
the shortest and most
1
Call 1-800-667-8721 anywhere in the US and Canada
B E F O R E Y O U B E G I N
declines
all
operation of
the
D U C T I N G
space.
ductwork to
This
kitchen::
Sirius at
U
N
L
BEFORE YOU BEGIN:
It is advisable to test run the
range hood before installation.
Please read this entire manual and
ensure that you are fully conversant
with the requirements and limitations
direct
route
possible.
wherever reduce the number of
transitions and turns with as few
sharp angles as possible.
Figure 1
Two staggered 45 degree angles are
better than one 90 degree.
these turns as far away from the
motor exhaust as possible, with as
much space between each bend.
accessories
I
M
I
T
E
D
www.kitchensource.com
-
Always,
Make
Advertisement
Table of Contents
