Troubleshooting - GreenWorks GPW 2000 Operator's Manual

PROBLEM
Motor buzzes but fails to
run.
No water.
NOTE: AUTO ON/OFF SWITCH: This Pressure washer is equipped with an Auto Start/
Stop feature. To operate: Press power switch On (I). Pump will pressurize and shut
down immediately. Once the trigger of the gun is depressed the unit will turn on. Unit
will shut off and be in standby mode when trigger is released.

TROUBLESHOOTING

POSSIBLE CAUSE
Supply voltage below
minimum.
System has residual
pressure.
Voltage loss due to
extension cord.
Pressure washer not
used for long periods.
Residual friction
among components.
Unit might hum.
Water supply is OFF.
Kink in the garden
hose.
EN - 27
SOLUTION
Verify that only the pressure washer is running
on this circuit.
Turn unit "OFF", squeeze trigger on spray
wand to release pressure, then turn unit "ON".
Unplug any extension cords attached and plug
the unit directly into the outlet.
Call the Toll-Free Helpline.
Disconnect water supply and power ON for 2
to 3 seconds, repeat couple times or until the
motor starts.
Turn ON water supply.
Remove kink in garden hose.