Troubleshooting - GreenWorks PW60L01 Operator's Manual

8

TROUBLESHOOTING

PROBLEM POSSIBLE
CAUSE
The motor does You do not in-
not start. stall the battery
pack
The power
switch is on, but
you do not pull
the spray gun
trigger.
The machine The diameter of
does not reach garden hose is
high pressure. too small.
Water supply is
restricted.
The water sup-
ply is not suffi-
cient.
Spray tip has
not be installed
onto the spray
wand properly.
The water in-
take filter is
clogged.
English
PROBLEM
SOLUTION
Install two bat-
tery packs with
full power.
Pull the spray
gun trigger.
Replace with a
1" (25 mm) or
5/8" (16 mm)
garden hose.
Check garden
The output
hose for kinks,
pressure varies
leaks, and
high and low.
blockage.
Open the water
supply fully.
Install desired
spray tip to end
of wand.
Remove filter
and rinse in
warm water and
then reinstall it.
15
POSSIBLE SOLUTION
CAUSE
The water sup- Open water
ply is not suffi- supply fully.
cient. Check garden
hose for kinks,
leaks, or block-
age.
The pump is 1. Make sure
drawing in air. that the
hoses and
fitting are
airtight.
2. Turn
"OFF" ma-
chine.
3. Purge
pump by
squeezing
trigger gun
until a
stead flow
of water
comes out
the spray
tip.
The water in- Remove the fil-
take filter is ter and Rinse in
clogged. warm water.
The battery Charge the bat-
pack is out of tery pack.
power.
The gun, hose Run distilled
or nozzle are vinegar through
calcified. detergent tank.
EN