GreenWorks GPW 2000 Operator's Manual page 23

SPRAY TIP MAINTENANCE
Excessive pump pressure (a pulsing sensation felt while squeezing the trigger) may be the result of a
clogged or dirty spray tip.
■ Unplug the pressure washer.
■ Turn off the pressure washer and shut off the water supply. Pull trigger to release water pressure.
■ Remove the spray tip from the spray wand.
NOTE: Never point the spray wand at your face.
Using the spray tip cleaning tool provided, free any foreign materials clogging or restricting the spray tip
opening. Refer to Fig. 15
■ Using a garden hose, flush debris out of the spray tip by back flushing (running the water through the
spray tip backwards or from the outside to the inside).
■ Reconnect the spray tip to the spray wand.
■ Turn on the water supply.
STORING THE PRESSURE WASHER
Store in a dry, covered area where the weather can't damage it.
It is important to store this product in a frost-free area. Always empty water from all hoses, the pump,
and the detergent container before storing.
NOTE: Use of a pump saver will give you better performance and increase the life of the machine.
Option (1):
■ Roll up the high pressure hose, and hang the hose to the cord arm.
MAINTENANCE
(See Figure 15.)
Cord Arm
High
Pressure
Hose
EN - 23
Fig. 15
(See Figure 16.)
Fig. 16