Maintenance - GreenWorks GPW 2000 Operator's Manual

Option (2):
■ Fix one end of the high pressure hose to the left side holder.
■ Turn the crank handle clockwise.
■ Attach the other hose end to the right side holder when the hose is fully wound for storage.
17-3.)
Fig. 17-2
Crank
Handle
QUICK WINTERIZING PROCEdURE
If you cannot do the Optimum Winterizing procedure, you can still protect your pressure washer from
winter damage by doing below:
■ Disconnect all water connections.
■ Turn on the machine for a few second, until the remaining water in the pump exits. Turn off immediately.
■ Do not allow high-pressure hose to become kinked.
■ Store the machine and accessories in a room that does not reach freezing temperatures. Do not store
near furnace or other sources of heat as it may dry out the pump seals.
C A U T I O N :
Drain gun assembly of any remaining water. Aim gun downwards and squeeze trigger.
SHUTTING dOWN ANd CLEANING UP
■ (If you are not using detergent, go directly to Step 2.) When you have finished using the detergent
injection system, fill detergent bottle with clean water. Siphon water at low-pressure for one minute so
that all detergent is flushed through system. Remove detergent bottle and rinse it thoroughly.
■ Disconnect the garden hose from the water inlet on the unit.
■ Press trigger to release any remaining water pressure.
■ Turn the switch to "OFF" (0) position.
■ Unplug the power cord from the outlet.
■ Engage gun safety lock.
TAKING A BREAK
If taking a break of five minutes or more.
■ Engage gun safety lock.
■ Turn unit to "OFF" (O) position.
■ Unplug the power cord from the outlet.
I M P O R T A N T :
The use of a pump protector is recommended when storing to help prevent a against freezing over the
winter months. It also help prevent the seals from drying out while sitting in storage in all climates.

MAINTENANCE

(See Figure 17-2.)
Left Holder
Fig. 17-1
EN - 24
(See Figure 17-1.)
Right Holder
Fig. 17-3
(See Figure