Packing List - GreenWorks GPW 2000 Operator's Manual

2000 psi / 1.2 gpm electric pressure washer
Hide thumbs Also See for GPW 2000:
Table of Contents

Advertisement

PART NAME
• Pressure Washer
• Upper Handle Assembly
(including the spray tips)
• Turbo Nozzle
• Sprayer gun (trigger)
• GW gun wand assy
• Gun Holder
• Spray Tip Cleaning Tool
• Screw ST15*20
• Wheels
• Operator's Manual
• Quick Start Guide

PACKING LIST

ERP NO.
25°Spray Tip (GREEN)
331011635
40°Spray Tip (WHITE)
(only for upper
Soap Tip (BLACK)
handle)
31208363
31140363-1
31145363
311201635
33201671
322011628
311011635
388011635
3880021635
EN - 10
FIGURE
This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk
Installin the wheels
WARNING:
Set-up
of injury or death, user must read and understand operator's manual before using this product.
Insert the axle through the wheel and through the frame.
1
Connect garden hose to pressure
Slide the washer over the axle pass the pin hole.
washer water intake.
Insert the pin through the hole to firmly fasten the wheel.
2
Assemble pressure washer gun to spray wand.
2000 PSI / 1.2 GPM
ELECTRIC PRESSURE WASHER
GPW 2000
USING DETERGENT
Put pressure washer detergent in detergent tank.
...
Connect desired pressure tip.
Install blue or black soap nozzle.
Squeeze trigger and wait approx.1 minute for soap.
Installin the n holder
ine up the screw sleeves with the holes in the upper handle and
push through.
...
Take one end of the hose off the holder.
Insert the screw and turn clockwise with a phillips head screw
Remove the high pressure hose
driver (not included) until the screw is tight.
completely from hose reel, then take the
other hose end off the holder.
Gun Holder
SPRAY TIP
SPRAY TIP APPLICATION
Red - Stream tip (0° )
5
The red 0 degree tip provides a straight line of spray. It provides the highest amount of
Insert high pressure hose into trigger
0
O
pressure. It is best used for removing hard, stuck-on grime or dirt.
handle.
Green - Narrow fan tip (25° )
The green pressure washer tip provides high versatility with its 25 degree angle tip. Referred to
as the washing tip, because it provides adequate pressure to remove dirt from surfaces, but is
designed to not damage many surfaces. This pressure washer tip is designed for "sweeping"
25
O
foliage or debris given its wide angle. This tip is versatile due to its wide area of cleaning and
6
Connect the high pressure hose to the
strong pressure application.
water outlet connector.
White - Wide fan tip (40° )
Screws
The white 40 degree tip, referred to as the "fan" tip creates the widest area of cleaning with
relatively low pressure. This pressure washer tip is best used for light or delicate cleaning
40
O
applications. It is recommended for light cleaning on wood decks and other soft or delicate
surfaces.
Black - Soap spray tip
7
Turn on water at outlet.
The black soap spray tip, is used for soap application. Soap is applied under low pressure
Installin the pper handle
SOAP
high volume for optimum performance. Soap cannot be applied under high pressure with this
machine.
Push and hold the push-pin button on the side of the upper
handle assembly (1) as you slide the handle onto the frame (2).
Storin the hi h press re hose
8
Run water hose for 120 seconds with the
Option (1):
motor in OFF position. This helps drain air
Cord Arm
from the tank and lines.
Roll up the high pressure
120S
hose, and hang the hose to the
High Pressure Hose
cord arm.
Connect power cord to wall outlet
9
Extension cord not recommended.
Option (2):
10
Turn on Pressure Washer
Fix one end of the high
Turn the crank handle clockwise.
Attach the other hose end to the
IMPORTANT: Ensure water outlet is On
pressure hose to the left side
right side holder when the hose
holder.
is fully wound for storage.
before turning power On to avoid damage
to the pump.
eft Holder
NOTE:
Missing parts, accessories or need a service center?
AUTO ON/OFF SWITCH: This Pressure washer is equipped
Right Holder
with an Auto Start/Stop feature.
Do Not Return to Store
To operate: Turn the power switch to the On (I) position. Pump will
Call : 1-888-909-6757
Crank Handle
pressurize and shut down immediately.
www.GreenWorksTools.com
Once the trigger of the gun is depressed the unit will turn on.
NOTE: Fully remove hose from the hose reel before use.
Unit will shut off and be in standby mode when trigger is released.
Rev:01
PART NO.
1
1
1
1
1
1
1
2
2
1
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents