GreenWorks GPW 2000 Operator's Manual page 14

ASSEMBLY
CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANdLE
(See Figure 7.)
1. Align the pressure hose with the trigger handle and push up and into position.
2. With hose pushed into position on the trigger handle, secure in place by turning the hose lock clockwise
until fully tightened.
NOTE: For easier installation of the hose to the unit or trigger it is suggested to add pressure washer or
dish detergent to the rubber seal at each end of the hose. This will allow for easier installation and a snug
fit.
①
②
Fig. 7
ASSEMBLING THE SPRAY WANd
(See Figure 8.)
■ Push the end of the spray wand into the trigger handle and rotate clockwise to secure.
■ Pull on the spray wand to be certain it is properly secured.
Fig. 8
EN - 14