Internet; Wan Service; Lte/3G - D-Link DWR-922 User Manual

Section 3 - Configuration
On this page you can configure your Internet connection. If you are not sure which settings to use, please contact your Internet Service Provider
(ISP).
Layer2 WAN Select your Internet connection type: LTE/3G or Ethernet WAN.
Connection:
If Auto-Detection does not work, then try selecting Manual and
Dial-Up Profile:
filling out the information (supplied by your LTE/3G ISP).
Authentication: Select PAP, CHAP, or AUTO detection. The default authentication
method is AUTO.
Roaming:
Check the box to enable international LTE / 3G roaming.
Reconnect Select either Always On, Connect on Demand, or Manual.
Mode:
Maximum Idle
Enter a maximum idle time during which the Internet connection
Time: is maintained during inactivity (if you selected Always On above,
this setting will have no effect).
Keep Alive: Select Disable or Use Ping depending on the settings required
by your ISP. If you select Use Ping, set the ping interval and the IP
address to ping.
D-Link DWR-922 User Manual

Internet

WAN Service

LTE/3G

8