Remote Instructions - Comfort Glow EF5675R Owner's Manual

Freestanding
Table of Contents

Advertisement

Available languages

Available languages

N
O
P
R
TEMERATURE BUTTONS DECRESE (P) INCRESE (Q): This electric fireplace is equipped with a thermostat.
Press the Temperature button "Q" to increase the temperature. Press the Temperature button "P" to
decrease the temperature. The electric fireplace heater and fan will only turn on if the temperature setting is
higher than the room temperature.
CHILD LOCK FEATURE (R): Push button "R" once to lock the control panel functions and remote functions.
Push again to unlock.
 Note: if the Remote Control is misplaced, press the master power "A" on the control panel for 3
seconds and the controls will unlock after a short "beep" sound.
FAN BUTTON (S): This is a High and Low setting for the fan and the heater. Note that the fan will only come
on if the thermostat temperature id set above the room temperature.
CELSIUS / FAHRENHEIT BUTTON (T): Press the "T" button to change the temperature reading on display
between °C and °F.
ESO-ENERGY SAVING OPTION (U): Press button "U" once to move the temperature setting easily to 68° F (20°
degrees C). Press this button again to release the appliance from the Energy Savings Option.
 Note: Direct the remote control at the appliance from 3-15 feet distance for the remote to function
properly.
 Note: For remote control battery replacement, use Lithium Cell CR2025 3V.

REMOTE INSTRUCTIONS

This heater includes a remote control. To operate the appliance using
the remote, ensure the red power light "B" on heater control panel is
S
on. Each remote control is shipped with a plastic tab inserted into the
battery chamber to prevent damage and power loss. Please remove by
T
pulling on the tab and removing it from remote.
ON/OFF BUTTON (N): Press button "N" to turn electric fireplace on.
Q
TIMER BUTTON (O): If a timer is desired, push button "O" once for a 1
hour timer twice for a 2 hour time, etc (up
show on the digital readout screen. To reset, keep pushing the timer
U
button "O" until it returns to your desired time setting.
~ 7 ~
to 12 hours). The time will

Advertisement

Table of Contents
loading

Table of Contents