Table of Contents
Advertisement
Parameter
Trap address
Trap port
SNMP version
5.8.2.12 Multicast
The multicast interface is shown as in Figure 5-33.
Multicast is a transmission mode of data packet. When there is multiple-host to receive the same data
packet, multiple-cast is the best option to reduce the broad width and the CPU load. The source host
can just send out one data to transit. This function also depends on the relationship of the group
member and group of the outer.
5.8.2.13 Auto Register
The auto register interface is shown as below. See Figure 5-34.
This function allows the device to auto register to the proxy you specified. In this way, you can use the
client-end to access the DVR and etc via the proxy. Here the proxy has a switch function. In the network
service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the auto
register function, the device can auto register to the proxy server.
5.8.2.14 Alarm Centre
The alarm centre interface is shown as below. See Figure 5-35.
Function
The read community will read/write/access all the objects the
SNMP supported in the specified name. The default setup is
write.
The destination address of the Trap information from the
proxy program of the device.
The destination port of the Trap information from the proxy
program of the device. It is for the gateway device and the
client-end PC in the LAN to exchange the information. It is a
non-protocol connection port. It has no effect on the network
applications. It is a UDP port not TCP port. The value ranges
from 1 to 165535. The default value is 162.
Check V1, system only processes the information of V1.
Check V2, system only processes the information of V2.
Figure 5-33
Figure 5-34
180
Advertisement
Table of Contents
