Table of Contents
Advertisement
Please refer to the following sheet for detailed information.
Parameter
WLAN type
APN/Dial No.
Authorization
Pulse interval
Important
If the pulse interval is 0, then system does not end 3G connection after
you close the extra stream monitor.
Pulse interval here is for extra stream only. This item is null if you are
using main stream to monitor.
5.8.2.4.2 Mobile
The mobile setup interface is shown as in Figure 5-25.
Here you can activate or turn off the 3G connected phone or mobile phone, or the phone you set to get
alarm message.
5.8.2.5 PPPoE
The PPPoE interface is shown as in Figure 5-26.
Input the PPPoE user name and password you get from the IPS (internet service provider) and enable
PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from the
IP address column.
Please note, you need to use previous IP address in the LAN to login the device. Please go to the
IP address item to via the device current device information. You can access the client-end via
this new address.
Function
Here you can select 3G network type to distinguish the 3G
module from different ISP. The types include WCDMA，
CDMA1x and etc.
Here is the important parameter of PPP.
It includes PAP,CHAP,NO_AUTH.
It is to set time to end 3G connection after you close extra
stream monitor. For example, if you input 60 here, system ends
3G connection after you close extra stream monitor 60
seconds.
Figure 5-25
174
Advertisement
Table of Contents
