Table of Contents
Advertisement
Color mode
5.8.1.2 Encode
5.8.1.2.1 Encode
The encode interface is shown as below. See Figure 5-16.
Please refer to the following sheet for detailed information.
Parameter
Channel
Video enable
Code stream
type
Compression
the grey part of the video, the distortion may occur if the white
balance is not accurate. Please note the video may not be
attractive if the value is too low. The recommended value
ranges from 40 to 60.
It includes several modes such as standard, color. You can
select corresponding color mode here, you can see hue,
brightness, and contrast and etc will adjust accordingly.
Figure 5-16
Function
Please select a channel from the dropdown list.
Check the box here to enable extra stream video. This item is
enabled by default.
It includes main stream, motion stream and alarm stream. You
can select different encode frame rates form different recorded
events.
System supports active control frame function (ACF). It allows
you to record in different frame rates.
For example, you can use high frame rate to record important
events, record scheduled event in lower frame rate and it allows
you to set different frame rates for motion detection record and
alarm record.
The main bit stream supports H.264. The extra stream supports
H.264, MJPG.
168
Advertisement
Table of Contents
