Table of Contents
Advertisement
Using the wired remote control mode
Connect the supplied remote cable to the remote control
unit's remote jack and the "REMOTE CONTROL"
terminal on the monitor.
When the cable is connected, the mode automatically
switches to wired remote control. When the wired remote
control mode is used, the remote control unit can be
operated even if no batteries are loaded.
VIDEO 1
VIDEO 2
VIDEO 3
L(MONO)
R
Y
CB/PB
CR/PR
L(MONO)
R
RGB 1
R/CR/PR
G/Y
B/CB/PB
HD
VD
L(MONO)
R
RGB 3
(Digital RGB)
RS MUST
ORE THAN
CONTROL
RATING
LOCK
NCE 6 OHM
ON /OFF
LEFT
REMOTE
CONTROL
EXTERNAL
CONTROL
CONTROL
LOCK
ON /OFF
REMOTE
CONTROL
EXTERNAL
CONTROL
Remote Control
Cable
To Remote Jack
E-7
Operating Range
* Use the remote control unit within a distance of about 7 m/
23ft. from the front of the monitor's remote control sensor
and at a horizontal angle of within 30°.
* The remote control operation may not function if the
monitor's remote control sensor is exposed to direct
sunlight or strong artificial light, or if there is an obstacle
between the sensor and the remote control unit.
LUME
INPUT SELECT
UP
LEFT/–
RIGHT/+
/EXIT
Approx.
7m/ 23ft
Handling the remote control unit
• Do not drop or mishandle the remote control unit.
• Do not get the remote control unit wet. If the remote
control unit gets wet, wipe it dry immediately.
• Avoid heat and humidity.
• When not using the remote control unit for a long period,
remove the batteries.
• Do not use new and old batteries together, or use different
types together.
• Do not take apart the batteries, heat them, or throw them
into a fire.
• When using the remote control unit in the wireless
condition, be sure to unplug the remote cable from the
REMOTE CONTROL terminal on the monitor.
POWER/STANDBY
30˚
30˚
Advertisement
Chapters
Table of Contents
