Battery Installation - ehang GHOST Operating Manual

BATTERY INSTALLATION

Place the GHOST on a horizontal surface to connect the battery. Push the battery into
the battery compartment
door, making sure that the battery is correctly seated inside the battery compartment. Do
NOT 'force' the door closed as this could damage the wires or the GHOST Drone itself.
If the door will not close easily, reposition the wires accordingly.
Before flight, ensure that the battery is correctly installed in the GHOST Drone. An
incorrectly installed battery may cause safety issues when flying, and may cause incorrect
voltage readings. An incorrectly installed battery may prevent take-off.
Ensure battery wire is correctly connected
(Red to Red, Black to Black)
BATTERY WARNINGS & TIPS
Use only the included GHOST battery charger.
Do not use the battery if the casing and included balancer is broken, deformed or inflated.
Always set the charge output volts to match battery volts.
Never allow battery temperature to exceed 140°F (60 °C)
Recharge your battery post-flight only after it has returned to room temperature.
Never leave a charging battery unattended, and do not place the battery or charger on anything
flammable. Do not store or charge the battery in direct sunlight.
Never disassemble the battery and do not modify the battery circuit. Never discharge below
3.2V per cell Never puncture the battery assembly or individual cells.
Store the battery between 11.4V and 11.6V (3.8V – 3.85V per cell).
Do not store the GHOST Drone with the battery connected. This will drain the battery and
possibly damage it.
Keep the battery away from children, animals, water, and fire.
If your battery breaks or becomes unusable, it must be recycled by an authorized electronic
waste facility. Batteries and other electronic waste must be disposed of in a strict manner.
Consult your local waste disposal agency for guidelines on battery disposal.
(inward as shown in the diagram below)
05
. Close the compartment