Led Legend - ehang GHOST Operating Manual

LED LEGEND

Be advised that the GHOST Drone does not have an on/off switch. To power on the
GHOST Drone, connect the GHOST battery. After connecting the battery, LED lights
will flash, two red and two blue. The red LEDs indicate the front of the GHOST Drone,
the blue indicate the rear. If the LEDs flash rapidly during GPS flight, land the GHOST
immediately.
LED legend
Blue Flashing
Blue Solid
Red Flashing
Red Solid
Note: After the GHOST is powered on, the red LED light will flash rapidly. Place the GHOST on flat,
even ground. After approximately five seconds, the GHOST can be unlocked and takeoff.
PRE-FLIGHT CHECKLIST
G-BOX, aircraft battery level high.
Check that propellers are installed correctly, secure, and damage-free.
Check that the motors turn the props freely and easily.
REMINDER FOR iOS USERS
Keep the G-BOX and mobile device together to ensure the connection does not drop while
using the GHOST Drone.G
Remember to enable the location function on your device, as the GHOST App can cache
local maps to ehance your flying experience (requires network connectivity).
Do not unlock and takeoff until the GPS has acquired at least six satellites.
Searching for GPS satellites.
Found six or more satellites, can unlock
and takeoff.
1.Before takeoff: Initializing
2.During flight: Low battery power
1.The Ghost is unlocked
2.During flight
13
LED Indicators