Follow-Me; Micro-Control - ehang GHOST Operating Manual

FOLLOW-ME

The Follow-Me function is enabled when the GHOST is in hover mode.
Note
Only use Follow-Me in an open area, as the GHOST Drone does not currently have
obstacle avoidance capabilities. If the user is changing elevation while travelling, the user
must manually adjust the GHOST Drone elevation, as the GHOST cannot dynamically
change elevation while in Follow-Me mode.
To use Follow-Me, GPS on the mobile device running the GHOST App must be enabled.
Only enable Follow-Me when the distance between the operator and the GHOST Drone is
more than 3m (10 ft.). When the user is travelling, it is advised that the user not stop
suddenly, as the GHOST Drone cannot come to a sudden stop. When coming to a stop,
stop slowly. If the user clicks another button in the GHOST App while in Follow-Me mode,
Follow-Me will disengage. Ehang recommends setting the Ghost Drone's height to be well
above the user so as to avoid any collisions or possible damage while using Follow-Me.

MICRO-CONTROL

The "Micro-Control"
allows the GHOST Drone to be
controlled at its current altitude.
The GHOST Drone must be in
Hover mode to
"Micro-Control."
When using Micro-Control, the GHOST Drone's front is indicated by red LEDs, the rear by
blue.The Micro-Control function can also be used to aid in fine-tuning the landing point of the
GHOST Drone when in Landing mode.
function
access the
MICRO
CTRL
Micro-Control
22
Hover Anytime
Scan this QR code
MICRO
Watch the "Micro-
Control" tutorial