Gimbal - ehang GHOST Operating Manual

CAMERA OPERATION
Charging
Power On/Off
Micro SD Card
Recording Time
Note:Quickly press the power button to change modes.
Press the Confirm button to start and stop recording.

GIMBAL

The GHOST gimbal is made from lightweight aluminum alloy and is used to carry a
camera.
SPECIFICATIONS
Weight
Accuracy
Operating Voltage
Angle Restrictions
Supported Cameras
INSTALLATION
1
Installing the camera.
Clamp the camera into the gimbal holder, and then tighten the long screws to hold
the camera in place.
The camera lens should be on the right side of the clamp when installed correctly.
Gimbal (with Clamp)
Connect a USB cable to charge the camera.
(When charging, do not use a charger that delivers more than 1000mA
or the camera may be damaged.)
Press the power button to turn on. To turn off, hold the power
button until "GOODBYE" appears.
Supports exFAT 32k formatted cards.
70 minutes @ 1080P when fully charged.
127g
±0.09°
7 V – 17 V
Roll ±45°/ Pitch -90°to +30°
EHang Sports Camera, GoPro3, GoPro 3+, GoPro4
08
Completion