Propeller Guards; Camera; Gimbal - ehang GHOSTDRONE 2.0 Operating Manual

UNLOCK: Remove the propeller in this direction.
Installation
1. Put the aircraft upside down on soft surface to avoid scratches.
2. Match the silver nut propellers with the L motors (with silver motor shaft), and tighten
the propellers according to the LOCK instructions.
3. Attach the black nut propellers to the R motors in the same way.
Disassembling
Keep the motor deadlocked in place with one hand and remove the propeller according
to the UNLOCK instructions.

Propeller Guards

It is optional to use the propeller guards.
Installation: Place the guards over the aircraft. Use the screwdriver to tighten the 3
screws.
Disassembling: Unscrew the three holding screws and remove the guard.
Note: We recommend using propeller guards in a complex environment, such as crowd,
group of buildings or obstacles.

Camera

The gimbal is compatible with GoPro 3, GoPro 3+, GoPro 4 and EHang camera. Camera is
not included in the box.
1. Remove the camera guard. Connect the gimbal black plug with the Camera USB
interface.
2. Use the camera guard to fix the Camera lens, and tighten the screws.
Completed Assembly

Gimbal

The gimbal is preassembled and ready to use. If one needs to dissemble the gimbal,
refer to the following instructions. The gimbal is compatible with GoPro 3, GoPro 3+,
GoPro 4 and EHang camera.
Gimbal spare parts
3-Axis Gimbal *1 Plate Adapter *1 Adapter Cable *1 Copper Pillar *4 Screw *4
Gimbal Assembly
1. Put the aircraft upside down on a soft surface to avoid unnecessary scratches, and use