lehman Trikes Monarch II Honda GL1800 Installation Instructions Manual page 41

LICENSE PLATE BRACKET INSTALLATION
7. See Fig. 3. Measure 5" of wiring from back
side of light and cut excess wire.
8. See Fig. 3. Install (2) female terminal pins and
(1) male connector to wiring from light.
9. See Fig 3. Install black clip (BT3001) to secure
wiring to plate. Cut plug from original license
plate light and add 34" of wire. Cover with heat
shrink.
NOTE: Connect license plate wiring as follows.
(-) Black wire on light to green on harness
(+) Red wire on light to brown wire on harness
10. Run wire through body grommet from back
side and install (2) male terminal pins and (1)
female connector.
11. See Fig. 4. Connect wiring and install light as-
sembly to bracket using the following hard-
ware.
• (2) M6 x 16 Button Head Bolts- CB1904
• (2) M6 Flange Lock Nuts– CN1902
41
Fig. 3
Fig. 4