Latch Assembly - lehman Trikes Monarch II Honda GL1800 Installation Instructions Manual

Latch Modification
1. See Fig. 1. Remove release cable and plastic
clip from LH latch assembly.
2. See Fig. 1. Bend cable tab straight.
3. See Fig. 1. Remove original release lever.
4. See Fig. 2. Install cable extension using the
following hardware.
NOTE: Tighten screw just enough to engage
lock nut. Over tightening will cause extension
bracket to bind up.
•
(1) Cable Extension– LB6319
•
(1) 10/32" x 1/2" Machine Screw– CS4066
•
(1) 10/32" Lock Nut– CN3068
5. See Fig. 2. Install latch assembly and cable
bracket to latch bracket using the following
hardware.
•
(1) Latch Mount Bracket– LB6302
•
(1) Cable Bracket– LB6320
•
(4) OEM Phillips Screws (From Saddle-
bag)
6. See Fig. 2. Install cable clip and cable to new
extension.
7. Test latches to verify they release at the
same time. Adjust rod length as needed.
Door may not release properly if latches do
not release together.
8. See Fig. 2. Install cable clamp to safety re-
lease cable. Loop cable through small hole in
cable extension bracket and crimp cable
clamp.
•
(1) Cable Clamp- CC1900
•
(48") Safety Cable
9. See Fig. 3. Complete latch assembly should
look as shown.
LATCH MODIFICATION
Safety
cable
31
Fig. 1
Bend cable tab straight
Remove release lever
Fig. 2
Cable bracket
Extension
Fig. 3
Remove clip and cable
Latch bracket