lehman Trikes Monarch II Honda GL1800 Installation Instructions Manual page 37

Table of Contents

Advertisement

5. See Fig. 4. Install trunk door to body using the
following hardware. Leave hardware loose.
• (6) M6 x 16 Button Head Bolts- CB1904
• (6) M6 Fender Washers- CW2107
CAUTION: Slowly close door and ensure strik-
ers clear top of trunk opening. Bend strikers
down if necessary. Strikers should just clear
opening.
6. Slowly close door (do not try to latch door at
this time). Adjust door from side to side and
up and down to match body. Once door is in
place, slowly open and tighten mounting hard-
ware.
7. See Fig. 5. Lower door and check for consis-
tent spacing between door and body.
8. Pull latch assembly towards rear of body and
tighten hardware. Align strikers from side to
side to match opening on each latch.
9. Latch door. Verify that both side latch when
closed. Adjust latch assembly in or out as
needed.
10. See Fig. 6. Door adjustment is made using the
following:
• Moving hinges upward in trunk results in the
top of door tilting outward and away from
body.
• Moving hinges downward will bring door
closer to body.
• Latch can be slide in or out to adjust gap on
top and take out any excessive play in door.
DOOR INSTALLATION
37
Fig. 4
Fig. 5
Fig. 6
Loosen bolt
and adjust
as needed
Door mounting
Consistent spacing

Advertisement

Table of Contents
loading

Table of Contents