Abs Disable - lehman Trikes Monarch II Honda GL1800 Installation Instructions Manual

ABS Disable (If applicable)
1. Disconnect battery and verify ignition is in the
"OFF" position.
NOTE: ABS control module location will vary
depending on model year. Refer to the Honda
service manual for access to module.
1. Remove all ABS related fuses from fuse panel.
Location will vary by year.
2. See Fig 1. Unplug ABS control module. Posi-
tion black 5-pin connector so the unplugged
end is facing you with 3-pin slots on the bottom
3. See Fig 1. Remove a small amount of plastic
between bottom center and bottom right pin
slots. Remove only enough material to install a
mini fuse.
4. Install 5 amp mini fuse from fuse panel into
bottom center and bottom right slots. Verify
that fuse connects yellow/blue wire (ABS light)
to larger green wire (ground).
5. Use electrical tape to cover plug and secure
fuse into place.
6. Reconnect battery and verify ABS light re-
mains off.

ABS DISABLE

47
Fig. 1