lehman Trikes Monarch II Honda GL1800 Installation Instructions Manual page 16

Brake System Modification- Front
1. Remove front fenders and wheel covers.
2. See Fig's. 1 & 2. Remove OEM line from anti-
dive valve and front master cylinder. Line con-
tinues to junction block located on steering
head. Disconnect lower hard line from block.
Remove block from frame and remove entire
line from motorcycle.
3. See Fig. 3. Install new brake line between anti-
dive valve and master cylinder using OEM
banjo bolts and the following hardware. Torque
banjo bolts to 18 ft-lbs.
•
(1) Front brake line- S002066
•
(4) Copper Banjo Washers– GC6002
PREPARING THE MOTORCYCLE
Anti-dive valve
Remove lower
line from block
16
Fig. 1
Master cylinder
Fig. 2
Disconnect
block
Fig. 3
New line installed