Chapter 3: Install Ram Mounting Brackets - Honeywell VX6 Installation Instructions Manual

Chapter 3: Install RAM Mounting Brackets

Caution: This device is intended to transmit RF energy. For protection against RF exposure to humans and in accordance
with FCC rules and Industry Canada rules, this transmitter should be installed such that a minimum separation dis-
tance of at least 20 cm (7.8 in.) is maintained between the antenna and the general population. This device is not
to be co-located with other transmitters.
Equipment Needed: Phillips No. 1 screwdriver and a Torque wrench capable of measuring to 50 inch pounds (5.64±.56 N/m).
Note: Torquing tool is not supplied by Honeywell. Bolts, washers, and wrench needed when attaching the bottom mounting
bracket to the vehicle are not supplied by Honeywell.
Several types of RAM mounting options are provided for the VX6:
RAM Ball or Ram Ball Mount Bracket
l
Available RAM ball base or RAM clamp mount
l
Remote mount for UPS battery pack
l
Before installation begins, verify you have the applicable vehicle mounting bracket assembly components necessary for your
mount type.
for back of the VX6
3-1