Strain Relief Cable Clamps - Honeywell VX6 Installation Instructions Manual

Strain Relief Cable Clamps

Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are strain relief cable clamps secured to the back of the VX6. Use the strain relief clamps to secure audio, power, and
I/O cables attached to the VX6.
1. Remove the strain relief clamp from the back of the VX6 by turning the screw counterclockwise. Put the screw aside in a
safe location.
2. Slide the strain relief clamp over the cable.
3. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the VX6. Do not
stretch the cable. Leave enough slack in the cable to allow it to be connected and disconnected easily when needed.
4. Continue in this manner until all cables are secured to the VX6.
4-9