Step 1B - Mount Vehicle Ram Clamp Mount - Honeywell VX6 Installation Instructions Manual

Step 1b – Mount Vehicle RAM Clamp Mount
Note: If you are using the RAM ball base, complete
1. Determine the position for mounting the RAM clamp mount. The clamp mount can be used on a beam (such as on a fork
lift truck) up to 2.5" (63.5 mm) wide and approximately 2" (50.8 mm) thick. The clamp may be attached to a thicker beam
by substituting longer bolts (not included). Be sure to position the RAM clamp mount to allow access to the switches
and ports on the bottom of the VX6.
2. Position the upper clamp piece with ball (A) on the beam. Place the bolts (B) through the holes in the upper clamp piece.
3. Position the lower clamp piece (C) below the beam. Align the bolts with the holes in the lower clamp piece.
4. Place the nylon locking nuts (D) on the bolts and tighten the bolts.
Step 1a and skip Step 1b.
3-5