Code Alarm CA 611 Installation Instructions Manual page 16

7. SYSTEM PROGRAMMING, CONTINUED
Security Programming Selectable Features
1. Enter the vehicle and turn the ignition key to the ON position.
2. Press and release the programming switch 3 times. The siren will chirp 1 time and the LED will flash
once.
3. Immediately turn the ignition key OFF then ON. The siren will sound 1 short chirp and then 1 long chirp.
4. You are currently in feature selection 1. Use the program switch to advance to the feature you want to
change. Note: There is no notification for advancing through options. The system will chirp to acknowledge
the default setting for each option after each press of the programming switch.
5. Use the LOCK icon button on the transmitter to change the setting of a feature.
IF YOU ALLOW MORE THAN 15 SECONDS TO PASS BETWEEN STEPS, THE PROGRAMMING
FEATURE SELECTION
1. Door Locks
2. IGN. Lock
3. IGN. Unlock
4. Passive Locks
5. Passive Arming
6. Siren/Horn
7. Horn Chirp
8. Override Method
9. Two Step Unlock
10. Chirp Delete
16
IMPORTANT!!!
MODE WILL BE TERMINATED
SECURITY PROGRAMMING CHART
1 Chirp 2 Chirp
1 Sec. 3.5 Sec
On Off
On Driver Only On All Doors
On Off
On Off
Siren/Horn Siren
10mS 16mS
Custom Code Valet
On Off
On Off
3 Chirp DEFAULT
Dbl. Unlock 1 Sec.
Off
Off Off
Off
Off
Horn Siren/Horn
30mS 16mS
Valet
Off
Off