Additional Connections; System Power-Up Procedure; System Programming - Code Alarm CA 611 Installation Instructions Manual

Hide thumbs Also See for CA 611:

5. ADDITIONAL CONNECTIONS

2 Pin Valet/Program/Override Push-Button: (Blue Connector)

The Gray wire populated in the two pin blue connector is the program/valet/override input of the Remote

Start/Security unit.

3 Pin Antenna/Receiver Connector: (White Connector)

Mount the supplied antenna/receiver to a clear spot on the vehicle's windshield that will not block the

driver's vision. A good location is usually high on the windshield near the rear view mirror. Be careful not

to mount the antenna/receiver on any metallic window film, as this will effect system range. Route the

antenna/receiver cable to the control module and plug into the 3 pin black connector.

4 Pin Shock Sensor Port: (Tan Connector)

The Red (+12 volt), Black (ground), Blue (pre-detect) and Green (full trigger when armed) wires loaded into

the white connector shell are the inputs/outputs of the shock sensor.

2 Pin LED Harness: (Off White Connector)

The Blue wire populated in the two pin white connector controls the LED.

2 Pin Neutral Safety Harness: (Red Connector)

The Black/White wire populated in the two pin red connector is the neutral safety input, connect this to the

vehicle's wire that shows NEG (-) when the gear selector is in park or neutral. The remote start feature of

this unit will not operate unless this wire is connected.

4 Pin Tracking Port: (Tan Connector)

For use with CODE ALARM telematic and Tracking accessories.

1. After all connections are complete, turn the vehicle's ignition key to the ON position.

2. Insert both 30 Amp fuses into their respective fuse holders.

3. Turn the ignition key to the OFF position

Transmitter Programming

1. Enter the vehicle and turn the ignition key to the ON position.

2. Press and release the programming switch 3 times. The LED and parking lights will flash 1 time.

3. Press and hold the LOCK icon button on the transmitter you wish to program for 4 seconds or until you see

a long flash of the parking lights.

Repeat step 3 for each additional transmitter you wish to program.

4. Turn the ignition key to the OFF position and test the functions on the transmitters.

IF YOU ALLOW MORE THAN 15 SECONDS TO PASS BETWEEN STEPS, THE PROGRAMMING

IMPORTANT!!!

MODE WILL BE TERMINATED