Fitting / Removing Brush Heads - Dentalux DAZ 2.4 A2 Operating Instructions Manual

• Place the hand element on the charging station 3 so that
it slides onto the spike in the base.
• Allow the hand element to charge up for approx. 14 - 16 hours
before using it for the fi rst time. The charging indicator 5
on the front of the hand appliance glows red during the
charging process.
• Use the hand element repeatedly, and without charging
the battery, until the performance is noticeably weaker or
the toothbrush stops working and the charge indicator 5
blinks red. First then recharge the battery for 14 - 16 hours.
When the appliance is fully charged, the charge indicator 5
glows green.
• Charge and discharge the toothbrush completely 3 times.
The battery will have then reached its full capacity.
• You can now leave the hand element in the charging
station 3 after every use, so as to always have full power
available.
For care of the batteries, we recommend the following:
When the hand element is fully charged, remove the plug
of the charging station 3 from the mains power socket. First
reinsert the plug into the mains power socket and recharge
the hand element when the movement of the toothbrush is
noticeably weaker or the charge indicator 5 blinks.

Fitting / removing brush heads

To remove the brush head 1, turn it clockwise and then pull
it upwards.
To fi t the brush head 1 place it slightly off set on the hand
element and then turn it anti-clockwise.
The brush head 1 must engage on being put back on. To avoid
damage to the appliance, use only original brush heads.
(For replacement brush heads, see the order card)
- 45 -