Mount The Pc Housing - Lenze EL 1800 Operating Instructions Manual

8.3.2

Mount the PC housing

With DVD drive

0
2
ƒ
4
Proceed as follows when a DVD drive is mounted:
1. Mount the housing 0:
– Pass the ribbon cable 1 through the housing aperture and carefully place the
housing 0 on the housing base.
– Screw in the three screws 2.
2. Only for fanless devices: Screw in the three screws 3 and tighten them.
The internal heatsink must be firmly connected with the housing. Otherwise, the heat
dissipation will not suffice, and the device might be damaged.
3. Mount the DVD drive 4:
– Plug on the ribbon cable 1.
– Carefully place the DVD drive 4 on the slots in the housing.
– Push the DVD drive 4 to the left until it snaps into place.
– Screw in the fixing screw 5.
BA_ELx8xx EN 3.0
‚
1
b
„
a 1
c
5
l
Maintenance
Mount the PC housing
3
6
8
Repair
ELx7xx−014
51