Lenze EL 1800 Operating Instructions Manual page 10

2 Safety instructions
General safety information
Transport, storage
Transport and storage in a dry, low−vibration environment without aggressive
ƒ
atmosphere; preferably in the packaging provided by the manufacturer.
– Protect against dust and shocks.
– Comply with climatic conditions according to the technical data.
Mechanical installation
Install the product according to the regulations of the corresponding
ƒ
documentation. In particular observe the section "Operating conditions" in the
chapter "Technical data".
Provide for a careful handling and avoid mechanical overload. During handling
ƒ
neither bend components, nor change the insulation distances.
The product contains electrostatic sensitive devices which can easily be damaged by
ƒ
short circuit or static discharge (ESD). Thus, electronic components and contacts
must not be touched unless ESD measures are taken beforehand.
Electrical installation
Carry out the electrical installation according to the relevant regulations (e. g. cable
ƒ
cross−sections, fusing, connection to the PE conductor). Additional notes are
included in the documentation.
When working on live products, observe the applicable national regulations for the
ƒ
prevention of accidents (e.g. BGV 3).
The documentation contains notes for the EMC−compliant installation (shielding,
ƒ
earthing, arrangement of filters and installation of the cables). The manufacturer of
the system or machine is responsible for the compliance with the limit values
required in connection with EMC legislation.
For compliance with the limit values for radio interference emission at the site of
ƒ
installation, the components − if specified in the technical data − have to be mounted
in housings (e. g. control cabinets). The housings have to enable an EMC−compliant
installation. In particular observe that for example control cabinet doors preferably
have a circumferential metallic connection to the housing. Reduce openings or
cutouts through the housing to a minimum.
Only plug in or remove pluggable terminals in the deenergised state!
ƒ
Commissioning
If required, you have to equip the system with additional monitoring and protective
ƒ
devices in accordance with the respective valid safety regulations (e. g. law on
technical equipment, regulations for the prevention of accidents).
10
l
BA_ELx8xx EN 3.0