Mounting Steps; Panel Pc El 1800(S) / El 1850(S) - Lenze EL 1800 Operating Instructions Manual

5 Mechanical installation

Mounting steps

Panel PC EL 1800(s) / EL 1850(s)

5.3 Mounting steps
5.3.1 Panel PC EL 1800(s) / EL 1850(s)
How to perform the installation:
1. Cut the mounting cutout into the control board (¶ 33).
2. Check that the gasket under the front panel is located correctly.
3. Place the device in the mounting cutout and secure it against falling−down with one
hand.
4. Fit all screw clamp fixings as explained below:

– Insert the screw clamp fixing into the slot in the housing of the device (see above
figure).
– Press the screw clamp fixing downwards, tilt it towards the housing and check
that it has firmly snapped into place.
– Tighten the screw clamp fixing hand−tight with a screwdriver.
5. Check that the device is securely located in the mounting cutout and that the front
panel gasket is located correctly.
– If necessary, realign the device/gasket.
– If the gasket is not located correctly, protection class IP65 is not achieved on the
front of the device!
34
‚
l
ƒ
ELx7xx−011
BA_ELx8xx EN 3.0