Operation - Worx WG169E.5 Operation Manual

7. ADjUStMeNt of AUXIlIARy HANDle
Pull up the Auxiliary handle Locking Lever (11).
hold the Locking Lever and rotate the Auxiliary handle
to the most comfortable and balanced position (See
Fig. G)
Release the lever, your Auxiliary handle has been
locked.
8. ADjUStMeNt of tHe tRIMMeR HeAD ANGle
a
to tHe SHAft (See fig. H1, H2 & H3)
WARNING! Make Sure the Safety Switch is
locked off to Prevent Accidental Starting.
To adjust the Upper Shaft angle or convert the tool
from trimming mode and edging mode, unlock the
Pivot head Locking Knob by hand, and using adequate
force, pull the trimmer head into the desired position,
then lock the Pivot head Locking Knob.
9. floWeR GUARD/eDGe GUIDe
Pull the Flower Guard/Edge Guide out before trimming,
as shown in Fig. i1.
When edging, pull Flower Guard/Edge Guide out also,
and keep to a side (See Fig. i2).
Before trimming or edging make sure the flower guard
is locked firmly in position.

OPERATION

WARNING! Always wear the eye protection.
Never lean over the trimmer head. Rocks or
debris can ricochet or be thrown into eyes and
face and cause blindness or other serious injury.
When operating unit, check for the following:
Wear eye protection and heavy clothing. Hold
front handle with one hand and Auxiliary Handle
with the other hand. keep unit below waist
level. Work only from your right to your left to
ensure debris is thrown away from you. Without
bending over, keep line near and parallel to the
ground (perpendicular when edging) and not
crowded into material being cut.
WARNING! Make sure that line is fed out
before operation. Make sure motor is up to
full speed before trimming or edging.
WARNING! only use 1.65mm diameter
cutting line. other sizes of line will not feed
properly and will result in improper cutting head
function or can cause serious injury. Do not use
other material such as wire, string, rope, etc.
3 in 1 Grass Trimmer/Edger
C
9
D
E
15
14
F1
F2
10
G
H1
H2
WG169E WG169E.5
11
16
WG169E.9
11