Reboot; Reset Config - D-Link DGS-1210-28 Reference Manual

5 Command Line Interface
Syntax
Description
Parameters
Restrictions
Example usage:
To display the contents of the IP routing table:
DGS-1210-28> show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway
---------------------------- ---------------
Total Entries :0
DGS-1210-28>

reboot

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To restart the Switch:
DGS-1210-28> reboot
% Device will reboot, please wait a few minutes to re-login.
DGS-1210-28>

reset config

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To restore all of the Switch's parameters to their default values:
s how iproute { <ipaddr> | s tatic }
The show iproute command will display the Switch's current IP
routing table.
<ipaddr> - Enter the IP address used here.
static – Specifies to display all the static routes.
None.
Interface
-------------- ---------
To reboot the Switch. If the Switch is a member of a stack, it may
be rebooted individually, without affecting the other members of
the stack.
reboot
The reboot c ommand reboots the system. All network
connections are terminated and the boot code executes.
None.
None.
To reset the Switch to the factory default settings.
res et c onfig
All configurations will be reset to the default settings.
None.
None.
8 9
8 9
D-Link Web Smart Switch User Manual
Hops Protocol
---------------